We are Sub-Dealer of Schottel rudder propellers, and also DWG Rudder propellers which is a quite new High quality American Rudder Propeller Navigator system, ( not thrust master, but similar ) which are hydraulically driven.
These can steer 180 degrees or 90 degrees on a twin system, where you can change the turning direction from
The propeller very fast from forward to reverse.
This gives a extremely good maneuverability.
 

We also supply the top quality Hydro Armor hydraulically driven Rudder propellers, and tunnel thrusters, these can be connected to existing engines or power packs, or can be supplied as complete system, with one engine serving several Rudderpropellers, cranes and or winches.

Further we represent Olympic rudder propellers and have a range of different new and used bow thrusters

Also we have been working in the rudder propeller busyness for more than 27 Years, and can give you a good advise and service.
 

The DWG standard configurations have a manual steering stand on the stern of the navigator.
Optional, we can supply these units including a wireless remote control system, to be able to operate
this navigator from any place on board, like in a wheel house, a crane cabin or even while walking on deck.

The Hp. Range each is 50 Hp. , 100 Hp., 125 Hp. 175 Hp. 225 Hp. 275 Hp. 415 up to 600 Hp. Each.
Also its possible to couple up the wireless remote controls, so you can operate two or more units with one remote control.
This to increase the total Hp. To for example 550 Hp. , 830 Hp. , 1200 Hp. or more, in total, if required.

The stem section can be mounted in the required height, with a range of 500 mm. up to 3500 mm.
( long reach version ) from the deck to the center of the propeller, without any modifications required.
This is a mechanical depth adjusting system, and can be made hydraulically if required.
The propeller diameter is approx.. 600 mm.
All the units have a stainless steel nozzle.
The 275 Hp. Navigators and bigger, have one engine, with the power divided over two propellers, to be able to keep the draft very low.

This makes these navigators very suitable for many types of pontoons and barges, and can easily be mounted from a lower pontoon to a higher pontoon, without making modifications.

Also all navigators have a hydraulic almost 90 degrees tilt system, to be able to lift up the leg very fast, for example to beach the pontoon, for transport, or do some works on the propeller if necessary.

This makes the navigators also extremely suitable for shallow water operation
 

Delivery time is at the moment approx... 2 to 4 Month's, depending on moment of order.

At this moment we also have one navigator in stock with 125 Hp. ( if not sold )
 
We can supply also bigger rudder propellers and bow thrusters thruster FROM STOCK.,
for example 4 L-drives 2000 Kw. each, two Z-drives 3000 Kw. each and two retractable 3000 kw. each, two bow thrusters with 1420 Kw. each and more.

Please contact us for more info..